Guo et al. studied different types of containers, namely, shell-and-tube, encapsulated, direct contact and detachable and sorptive type, for mobile thermal energy storage applications. In shell-and-tube type container, heat transfer fluid passes through tube side, whereas shell side contains the PCM. It was reported that though. .
Omari et al. computationally studied the effect of different enclosure geometries, such as, rectangular, rounded rectangular and circular on the heat transfer enhancement for cooling. .
Food and drug storage/transportation are of prime importance in the present world. The temperature controlled environment is mandate to safeguard the. .
Sharma and Chen reviewed the usage of PCMs for thermal energy storage for solar water heating systems. Salunkhe and Devanuri gave a thorough review on suitable PCMs for solar.
[pdf] Thermo-electrical energy storage (TEES) based on thermodynamic cycles is currently under investigation at ABB corporate research as an alternative solution to more consolidated but site-dependent electricity stor. .
Thermo-electrical energy storage (TEES) is based on the conversion of electricity into thermal e. .
To understand the impact of the superheating before the HP compression on the maximum roundtrip efficiency, a separate optimization of the same base case configuratio. .
Starting from the base case topologies of the HP and TE cycles introduced in Fig. 2, alternative system structures were generated following an organized procedure base. .
The present work aims at describing a methodology for the synthesis and design optimization of thermo-electrical energy storage (TEES) systems and at showing the maximum effi. .
1.Cahn R.P. Thermal energy storage by means of reversible heat pumping. US patent 4089744, 1976.Google Scholar2..
[pdf] 
The connection interface between the accumulator and the hydraulic system can be described by two variables: the actual flow rate of the fluid entering the accumulator Qa and the fluid pressure at the accumulator inlet pa . Since the accumulator stores the hydraulic fluid by compressing the gas in it, the actual flow rate of. .
Hydraulic motor/pump is an energy conversion device. It converts hydraulic energy to mechanical energy when operating in motor mode, and mechanical energy to hydraulic energy while operating in pump mode. Thus, it. .
The reservoir normally has a slightly higher pressure than the minimum intake pressure of the hydraulic motor/pump to ensure proper operation.. .
The generator converts the mechanical energy from the hydraulic motor to electrical energy. A Surface-Mounted Permanent Magnet Synchronous Generator (SM-PMSG) is chosen to simplify the analysis as. .
The main hydraulic components are connected by pipelines, including pipes, hoses, unions, fitting, bends, valves, etc. All these connecting.
[pdf] 
